Coleman 5177 User Manual download pdf (Page 5)

English-4

■ Push lighted match

through lighting hole,

hold near mantle and

open fuel valve fully.

(Fig. 15)

Match Light

Lantern

INSTASTART™

Electronic

Ignition Lantern

CAUTION

• SERVICE SAFETY

• Keep all connections and fittings clean.

Inspect propane cylinder and lantern propane

connections for damage before attaching.

• During set up, check all connections and

fittings for leaks using soapy water. Bubbles

indicate a leak. Never use a flame.

Fig. 15 Fig.16

■ Open burner valve

and repeatedly push

igniter button and

ignite the mantles.

(Fig. 16)

WARNING

• BURN HAZARD

• Never leave lantern unattended when hot or

in use.

• Keep out of reach of children.

NOTE: If lantern does not

light, repeat above step. If

the lantern does not light

after several attempts,

check for a spark while

clicking the igniter. If no

spark is present, check

the electrode gap. The

gap should be about .2"

(5 mm). Carefully bend

electrode to set gap. If the

lantern is wet due to rain, high humidity, etc., the

electrode may not spark. Use lighting procedure

for match light version lanterns. (Fig. 17)

■ Brightness may be

adjusted with

fuel valve. (Fig. 18)

Fig. 18

To Turn Off

■ Make sure lantern

is cool.

■ Move lantern away

from flame (including

pilot lights) and other

ignition sources.

■ Remove propane

cylinder from lantern.

(Fig. 20)

■ Replace protective

cap on propane

cylinder.

■ Turn fuel valve off.

(Fig. 19)

Fig. 20

To Store

Fig. 19

DANGER

• EXPLOSION - FIRE HAZARD

• Never store propane near high heat, open

flames, pilot lights, direct sunlight, other igni-

tion sources or where temperatures exceed

120 degrees F (49°C).

• The cylinder must be disconnected when the

lantern is in storage.

■ Lantern can

be placed in

base for secure

storage. (Fig. 21)

Fig. 21

Fig. 13

Fig. 14

■ Reflecting position.

Bottom tab rests inside

lantern frame. (Fig. 13)

■ Storage position.

Reflector hangs from

back rails. (Fig. 14)

.2"

(5 mm)

Fig. 17

■ Assemble reflector to back of lantern. Position

the reflector clips onto the center of the two back

rails and slide either

upward into the

reflecting position or

downward into the

storage position.

(Fig. 12)

Fig. 12

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Coleman 5177 User Manual Page 5

Comments to this Manuals

Related products and manuals for Sports and recreation Coleman 5177