Coleman 5177 User Manual download pdf (Page 4)

English-3

■ Remove lantern parts from package.

Base

Ventilator-Globe-Bail

Assembly

Lantern Frame

Igniter Electrode

Mantles

Fig. 1

Fig. 2

■ Light bottom of mantle evenly. Burn until nothing

but white ash remains. Once the mantle has

been burned, it is very fragile. Be careful not to

touch it with finger or match. (Fig. 3, 4)

■ Complete assembly. (Fig. 5, 6)

Fig. 6

Fig. 3

Fig. 4

To Light

WARNING

If you smell gas:

1. Do not attempt to light appliance.

2. Extinguish any open flame.

3. Disconnect from fuel supply.

4. Call 1-800-835-3278.

WARNING

• Replace any mantle with a hole in it. A hole

can cause lantern to overheat and create a

hazard. Never operate lantern without

heat shield.

■ Take lantern outdoors

away from

ignition sources.

■ Turn fuel valve off.

(Fig. 7)

■ Remove protective

cap from top of

propane cylinder.

Save cap for use

in storing. (Fig. 8)

■ Note: Use Coleman 16.4 oz. disposable propane

cylinders. The LP-gas cylinder(s) used with

lanterns must be constructed and marked in

accordance with the specifications for LP-gas

cylinders of the U.S. Department of Transportation

Transport Canada, CAN/CSA B339

Fig. 7 Fig. 8

DANGER

• EXPLOSION - FIRE HAZARD

• Propane is heavier than air and can accumu-

late in low places. If you smell gas, leave the

area immediately.

• Always attach or detach propane source out-

doors; never while lantern is lighted, near

flame, pilot lights, other ignition sources or

while lantern is hot to touch.

• Always light & use lantern outdoors.

• This lantern must not be exposed to flamma-

ble vapors or liquids during lighting.

• This lantern is red hot during use and can

ignite flammables too close to the mantles.

Keep flammables at least 12 inches from the

sides and 48 inches from the top of the

lantern. Keep gasoline and other flammable

liquids and vapors well away from lantern.

■ Screw propane cylin-

der into lantern. Take

care not to cross-thread.

Hand tighten only.

(Fig. 10)

■ Set lantern into base.

(Fig. 11)

Fig. 10 Fig. 11

Ball

Nut

Fig. 5

■ Always extend base before use. (Fig. 9)

Fig. 9

Reflector

■ Always use genuine Coleman® #21 size

mantles. If using Insta-Clip® II tabbed mantles,

follow the instructions on the mantle package.

■ If using tie style mantles, tie mantles around

grooves in burner. (Fig. 1)

■ Distribute folds on mantle evenly. Cut off surplus

string 1/4" (0.6cm) from knot. (Fig. 2)

■ For INSTASTART™ electronic ignition lanterns,

be careful that mantle does not snag

on electrode.

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Coleman 5177 User Manual Page 4

Comments to this Manuals

Related products and manuals for Sports and recreation Coleman 5177