Coleman EVEN HEAT Owner's Manual download pdf (Page 10)

Lighting — EVEN HEAT™ Burners:

1. Open the lid

2. Make sure all burner control knobs are turned “OFF”. (Push the

control knob in and turn clockwise, to ensure that the control knob

is in the “OFF” position.)

3. Turn the LP tank valve ON slowly (turn counter clockwise). Wait for

pressure to stabilize for 5 seconds.

4. Push in and turn selected control knob counter clockwise to the

MAX position (

5. Push the INSTASTART™ ignition button. You should hear rapid

clicks. Repeat if necessary.

6. Check that the burner is lit

7. After the burner is lit you can turn on the other burner control knobs.

If the EVEN HEAT™ burner fails to light properly within 3-5 seconds, turn the burner control knob o. Also

turn o the L.P cylinder valve. Wait ﬁve minutes before attempting to light the burner again. This will allow

time for released gas to disperse.

WARNING

The burner control knobs must be in the “OFF” position before turning on the liquid propane

cylinder tank valve. If left in the “ON” position, when the LP cylinder valve is opened, the

“Flow Limiting Device” feature will activate, limiting the ﬂow of gas from the LP cylinder. If

this should occur, turn “OFF” the LP cylinder valve and burner control knobs and follow the

“Resetting the ﬂow limiting device instructions”.

WARNING

Never stand with your head directly over the barbecue when preparing to light the main burners,

to prevent possible bodily injury.

Match-lighting—EVEN HEAT™ Burners

Repeat steps 1-3 “Lighting - EVEN HEAT™ Burners” above.

4. To match light: push in and turn the far left burner control knob

counter clockwise to the MAX position (

5. Immediately strike a match or use a butane lighter, and position

through the lighting hole on the left side of the burner box. Shown

in ﬁgure A. Check to ensure that the burner is lit.

6. To light the other burners, press in and turn the nearest control

knob. The ﬂame will track around the burner and light via the

carryover tubes. Allow the grill to preheat with the grill lid closed

for 10-15 minutes before cooking.

Lighting- Side Burner / Sear Stove (if applicable)

1. Open the side burner lid

2. Check that the side burner valve is turned “OFF”.

3. Turn the LP tank valve ON slowly (turn counter clockwise). Wait for pressure to stabilize for 5 seconds.

4. Push down and turn the side burner control valve to MAX (

5. Press the INSTASTART™ Ignition button. You should hear rapid clicks. Check to ensure that the burner

is lit. Repeat if neccessary.

The side burner lid is for storage only. Wait until cool before closing.

CAUTION

Side burner ﬂame may be dicult to see on a bright sunny day

OPERATION — LIGHTING INSTRUCTIONS

OFF

MIN

MAX

Model may not be exactly as shown.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Comments to this Manuals

No comments

Coleman EVEN HEAT Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Barbecues & grills Coleman EVEN HEAT