Repair and Replacement ProceduresModel 5040 A SeriesConsumer Replacement Items®
101. New mantles will not lightusing the igniter.Mantles will not light using amatch.2. New mantles are dim afterbeing lighted.3. New mantles are di
111. Pilot will not light using theigniter (or with a long match –“A” models only).2. Pilot flame is long and yellow(and main burner is not yet on).
2451261111416157210938172018211319No. Part No. Description1 5040-1561 Reflector2 5040A5441 Pilot Assembly (Including tip switch)3 5040-1211 Glass Fram
© 2003 The Coleman Company, Inc.3600 North Hydraulic, Wichita, KS 67219 U.S.A.1-800-835-3278 or TDD 316-832-8707Coleman®and are register
4To repair or replace reflector, refer to Figure 1.Remove four hex-head screws holding reflector to burner head using a 11/32" wrench (Figure 1).
5To repair or replace the burner, refer to Figures 1-3, and Figures 6-7.Remove reflector (Figure 1). Remove burner screen assembly top as a unit by re
6To replace knob(s), refer to Figure 12.Note: Knobs are a friction fit. To remove pull straight out on knob (Figure 12). When replacing knob,flat side
7To replace burner caps, refer to Figure 15.Using a pair of pliers unscrew each burner cap as shown (Figure 15). When reinstalling burner capsapply an
81. My heater is “wobbly”2. During assembly some holesdo not completely line up.3. The three small holes,spaced at 120 degrees each, atthe end of the
91. Rotary igniter is loose.Battery-operated igniter is loose. 2. No spark is visible at elec-trodes when rotary igniter isrotated (or when battery-o
Comments to this Manuals