Coleman 5178 Series Instruction Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
English-4
Push lighted match
through lighting hole,
hold near mantle and
open fuel valve fully.
(Fig. 12)
Match Light
Lantern
INSTASTART
Electronic
Ignition Lantern
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and lantern propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
Fig. 12 Fig.13
Open burner valve
and repeatedly push
igniter button and
ignite the mantles.
(Fig. 13)
WARNING
• BURN HAZARD
• Never leave lantern unattended when hot or
in use.
• Keep out of reach of children.
NOTE: If lantern does not
light, repeat above step. If
the lantern does not light
after several attempts,
check for a spark while
clicking the igniter. If no
spark is present, check
the electrode gap. The
gap should be about .2"
(5 mm). (Fig. 14)
Carefully bend electrode
to set gap. If the lantern is wet due to rain, high
humidity, etc., the electrode may not spark. Use
lighting procedure for match light version lanterns.
Brightness may be
adjusted with
fuel valve. (Fig. 15)
Fig. 15
To Turn Off
Make sure lantern
is cool.
Move lantern away
from flame (including
pilot lights) and other
ignition sources.
Remove propane
cylinder from lantern.
(Fig. 17)
Replace protective
cap on propane
cylinder.
Turn fuel valve off.
(Fig. 16)
Fig. 17
To Store
Fig. 16
DANGER
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open
flames, pilot lights, direct sunlight, other igni-
tion sources or where temperatures exceed
120 degrees F (49°C).
The cylinder must be disconnected when the
lantern is in storage.
Lantern must
be placed in
base for secure
storage. (Fig. 18)
Fig. 18
.2"
(5 mm)
Fig. 14
Page view 4
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments